A double-sided golf grip tape used for factory and clubhouse installations. This tape can also be used for mounting, holding, splicing, tabbing and fastening of a variety of other substrates for which an aggressive, double-faced tape is needed. The grip (liner) side adhesive on the tape is specially formulated for effective golf grip installation while the shaft (exposed) side adhesive is designed for superior adhesion to graphite, steel and titanium.
Features & Benefits
- Double-coated crepe paper golf grip tape
- Fast set-up and easy clean-up
- Good tensile strength
- Superior adhesion to a variety of substrates
- Wrinkle-resistant tape and liner
Made in the U.S.
Typical Applications
- For factory and clubhouse golf grip installation
- Can also be used for mounting, holding, splicing, tabbing and fastening a variety of substrates when an aggressive, double-sided tape is required
Technical Information
Shurtape GG-200 Double Coated Crepe Paper Tape [Golf Grip Installation]
- Adhesive: rubber-based
- Carrier/Backing: crepe paper
- Release Liner: siliconized, crepe paper
- Thickness: 6.5 mils (carrier, adhesive)
- Adhesion: 50 ounces per inch (to stainless steel test panel)
- Tensile Strength: 23 pounds per inch (longitudinal)
- Service/Operating Temperature: 50°F to 150°F
- Elongation: 10%
-
Core: 3" diameter
Additional Product Information 
Safety Data Sheet
GG200 Specs
Regulatory Compliance Letter
Nominal Tape Widths vs Actual Widths
Tape rolls are cut to standard tape industry metric widths of approx. 24mm per 1-inch of nominal width ordered. As a result ACTUAL tape widths are normally 5% narrower than the NOMINAL width shown in inches. Examples:
- 1" Nominal width = 15/16" (24mm) Actual width
- 2" Nominal width = 1-7/8" (48mm) Actual width
- 3" Nominal width = 2-13/16" (72mm) Actual width
Note that tape rolls are NOT guaranteed to be splice-free.
